Crossfire connections

Wicked_and_Crazy · 15-12-2006, 18:13

When connecting a montor to a machine with Crossfire installed. Are you supposed to connect the monitor to the Y cable? i assume so as why would it have a socket to make a Y and not just be a jump lead.

Or, do you connect it to the spare output on the crossfire card?

---------- Post added at 18:13 ---------- Previous post was at 18:09 ----------

ahhh must be to the cable as crossfire wont enable if connected to a card direct.

hmmmm me starting to suspect a duff card or cable

15-12-2006, 20:30

oh dear have you changed the driver? run each card on its own to see which is at fault if the driver does not work?

Wicked_and_Crazy · 15-12-2006, 23:46

Quote:

Originally Posted by zinglebarb

oh dear have you changed the driver? run each card on its own to see which is at fault if the driver does not work?

no not yet, not sure why i should bother when an eng is going to turn up soon.

Just wierd that it works fine in windowed mode but not full screen

I did try the crossfire card on its own and that worked fine in windowed and non windowed modes so i assume its the other card thats at fault. Especially as i couldnt get picture at all when i tested it quickly. Need to spend some more time proving it i guess.