Crossfire connections
 

When connecting a montor to a machine with Crossfire installed. Are you supposed to connect the monitor to the Y cable? i assume so as why would it have a socket to make a Y and not just be a jump lead.

Or, do you connect it to the spare output on the crossfire card?

---------- Post added at 18:13 ---------- Previous post was at 18:09 ----------

ahhh must be to the cable as crossfire wont enable if connected to a card direct.

hmmmm me starting to suspect a duff card or cable

Re: Crossfire connections
 

oh dear have you changed the driver? run each card on its own to see which is at fault if the driver does not work?

Re: Crossfire connections
 

no not yet, not sure why i should bother when an eng is going to turn up soon.

Just wierd that it works fine in windowed mode but not full screen

I did try the crossfire card on its own and that worked fine in windowed and non windowed modes so i assume its the other card thats at fault. Especially as i couldnt get picture at all when i tested it quickly. Need to spend some more time proving it i guess.