Quote:
Originally Posted by Incomplete
Loop loss averages 10dB / km. Another 3dB or so is added by CPE equipment. I'm spot on for that, 1.4km line, 17dB downstream attenuation.
---------- Post added at 08:19 ---------- Previous post was at 08:17 ----------
Ewww Talk Talk 
|
Who states the average is 10db loss per km? I have seen it quoted by mrsaffron on adslguide but I do not just use my experience I use everyone who reports theirs. Most people who report their stats and line length have a higher then 10db loss per km and I think that is either a made up figure or miscalculated.
I stand by what I said based on reported figures the average loop loss is considerably above 10db per km most likely due to poor quality cabling. For some people its over 20db per km so I have not based on high end and my own line is actually 17db loss per km.
I would use long lines as a better comparison.
My sisters line is 0.8 real length 0.3 straight and is also 17db attenuation.
Friends line is 4.9 real length 4.4 straight and is 48 db attenuation (so almost 10db loss per km)
Another friend is 1.5 real length and has 39 db attenuation
Various people have reported their attenuation and know their actual line lengths and all are around 15 per km loop loss.
This 10db I suspect is based on specs for good quality new copper which doesnt apply to most of BTs local loop.
I can see now why you so happy about BTs loops you are one of the lucky 25% with a short line, and many of these take the I am alright Jack attitude in that because they have good specs they assume all is good.