There is a way round this but it requires a little knowledge of DOS. Firstly download the DOS 6.22 Bootdisk here,
http://www.akcent.pl/pub/firma/boot622.exe
Then run the file and follow the instructions (Blank Floppy disk needed).
Then reset the computer and boot from the floppy (this will only work if your machine boots from a floppy first (most do)) this will take you to DOS mode.
This disk also contains CD-Rom drivers so when it loads your CD-Rom will be mounted and available for use. Now the CD-Rom drive will be R: (but if you have more than one CD-Rom it could be S: or T: etc,) so on the screen type
R:
followed by return, Now type
dir
followed by return - if this is your Cd-Rom drive you will now see a whats on the Windows 2000 disk (make sure its in the drive

).
If its not type S:, then T: etc and try again until you find it.
When you have the correct drive type
setup
followed by return, The windows 2000 installation will then start.
Good luck