Quote:
Originally Posted by heero_yuy
Firstly can you log into your SH?
Remember that the hub must be powered up and stable before your PC and/or router are started.
Type 192.168.100.1 into your browser. Do you get the logon page?
If not then check to see if you've been granted a local IP address. Open cmd and type "ipconfig /all" This should report an IP something like 192.168.1.2
If you've got a logon page from the SH then click on "router status" top right and report your power levels upstream and downstream.
DS is ideally 0dBmv +/- 6dBmv RMXR > 33
US 35-50dBmv
That'll see if you're connected properly to the cables.
|
Likely got the Hub3 so it will all be different for logging in and finding the settings.
I use
http://192.168.0.1/ to log in to my Hub3.