Quote:
Originally Posted by jb66
Why can't there be dedicated trained staff who can look at redtools and then decide if it can be done remotely. Or better yet post out a 6db attenuator etc, this will dramatically bring lead times down
The amount of money wasted sending techs to add a little block to a bit of coax is embarrassing, just have a look at the community forum.
"oh your signal is 8db, that's why your connections slow". Then I go out add a 6db attenuator and the connection is the same..
|
Well it will help it NOT slow down.
Are you aware of noise in the slope of the signal between the high end and low end ?
Adding this simulator/attenuator/equaliser will reduce the slope and reduce the noise thus (in theory) better service
If its the same speed try using your own programmes. If there slow it's your comp