help sanyo tv

[hairy_mick]

I have a 28inch sanyo tv the picture has got streched verticaly
it needs setting from engineer screen the waranty company has gone bust sanyo wont tell me how to access the screen from my remote had it done a year ago by engineer but would not tell me how to do it. I feel like i have been shafted.

[Pritch]

What model is it?

[hairy_mick]

modle 28wp4 Pritch

[Bifta]

try this

Press & release diamond memory key on front ("Factory" shows on screen), press Index/Menu on hset within 5 secs; 1st tab on serv menu highlighted to allow entry of config code (02014) from handset. Pressing the R/C menu key again changes OSD to next setting, then alter with "Vol+" & "Vol-". To alter next parameter press sound button (under Vol+ button) to highlight next tab. Recommended values:- HO=02140; SO=01012; S1=00081; AO=00186; YO=00050; PO=15861; ZO=01369; P1=01665; Z1=00087; SP=00009

don't know if it's for your specific model, but worth a squirt

[Bifta]

You could also try this:

1. With the set turned on, unplug the AC cord. 2. On the front of the set, press and hold the Volume up and Channel up buttons. 3. Plug in the power cord. Press Channel up or down to change the adjustment function. Press Volume up or down to change the value of the adjustment function. Exit the service mode by pressing the power button. Data will save automatically. S01 PictureS02 TintS03 ColorS04 BrightnessS05 SharpnessS06 Vertical PhaseS07 Horizontal PhaseS08 RF-AGCS09 Vertical AmpS10 VCOS11 R Cut-offS12 G Cut-offS13 B Cut-offS14 G GainS15 B GainS16 Trap (3.58 Mhz)S17 BalanceS18 C.C. PositionS19 Y-MuteQP Option (set to each mode)M01 MTS LevelM02 Stereo-VCOM03 FilterM04 Low SeparationM05 High SeparationM06 P in P Y-levelP01 P in P TintP02 P in P ColorP03 P in P Y-offsetP05 P in P H-positionP06 P in P Burst Gate PulseP07 P in P Free RunIf you get really stuck, holding down both the Channel up and down buttons on the TV set while in the service mode form more than two seconds will rewrite all data to factory data. Note: Factory data has all cut offs at 0 and will create an excessively dark picture. You will still need to adjust the picture afterward

[Bifta]

or even this

2) Pressing both the MENU key and the TV/VIDEO key on the main body, turn on the power. Then, press the volume

If none of these work, look in the yellow pages for a tv repair company, most of the smaller one's will happily help you out over the phone FOC

[hairy_mick]

cheers Bifta i will give that a go