Cannot Change USB To Ethernet

hakkiki · 14-05-2005, 11:17

I am trying to setup a wireless broadband router. To do this I have to first of all have my broadband running off ethernet. I currently have it setup through USB. When running the NTL setup CD and selecting ethernet, it then brings up an error saying Non Functioning adapter USB31500. I followed the instructions for disabling and removing this adapter but it is still saying the same message.

Any suggestions would be much appreciated.

poolking · 14-05-2005, 11:28

Don't use the CD.

Do a search through the knowledgebase on the forum for setting up without using the CD.

hakkiki · 14-05-2005, 11:57

Cheers for that. I found a thread, I'll give it a go.

geminian68 · 14-05-2005, 12:04

hakkiki

to the site.

The following pages, should help you.

Quote:

Doing without the Broadband installer

If you cannot get the Broadband installer to run at all, then you can probably get on-line manually by:

configure networking as described in Network Settings;
register with your cable ISP as described in Registration Issues.

gem

hakkiki · 14-05-2005, 12:13

Cheers for that. Quick question, will them processes for using ethernet still work fine if I currently have it setup for USB or will I have to remove USB before trying them.???