Quote:
|
Originally Posted by Strzelecki
If that passes ok then try this:
In DOS prompt as before run both of these commands:
q:\drivers\tattoo /importbin:c:\tattoo.bin
q:\drivers\exths /importextbin:c:\exths.bin
When this is done, reboot and boot off your recovery CD again. If your CD fails then you will have to purchase the recovery Disks/DVD. Contact nffc at PC Servicecall for that!
|
Tried that. When doin the 1st 1 it says "bin.exe" "no bin file"
2nd 1. "File Error"
---------- Post added at 07:55 ---------- Previous post was at 07:54 ----------
Quote:
|
Originally Posted by nffc
OK, drop down to a Dos command line by pressing Esc at that message
then type TS - hit enter
Choose Option 1 (Dos Commands) then Enter
Choose Option 1 again (should be something complex like TreeCRC bleh)
This will check your CD make sure there's no errors on that.
This message comes up before or after you opt to start the recovery? What comes up before?
|
This comes up before I get to chose anything. It boots, goes through lots of Command Line and then I get the message
---------- Post added at 07:56 ---------- Previous post was at 07:55 ----------
+no errors on cd, hard drive, or ram. checked them all