[bel_ami_boy]

Originally Posted by Paul

Same way as sharing the internet but you don't plug anything into the WAN socket as far as I know.

Thanks for the quick reply Paul. I haven't connected any phone cables to the router. I've kept the phone cable going from the modem (on the Mesh PC) to the wall socket.

Originally Posted by Paul

You should be able to connect to a certain IP address or www address to access the setup pages and then it's a case of setting the router to talk wirelessly to the PC you want to connect to without a cable.

Yes the user guide quotes an IP address to access their set up pages. As yet I haven't been able to get the page up....the browser says it is timing out.

Originally Posted by Paul

Can the PC connected via cable see the router? Power off the router, power of the PCs, Plug the PC in to it, power up the router, let the lights stabilise, power up the pc connected to it by cable, look in the manual for the address you need to point the PC at but make sure you have set the browser to not dial a connection while you are setting the router up.

No it can't see the router (although where would I see this?). Your instructions are spot on with the user guide and I did power each unit up in the correct order. There is nothing in the user guide about inputting an address to point the PC at. Also if I have to use Linksys online setup pages to configure the router then I will need to use my Internet connection, unless I've misunderstood your last point?

Appreciate your help.