Cable Forum - View Single Post - media centre or u.s.b tv card to telewest?

xander.uk · 17-07-2005, 08:24

hi stewart thx for your reply.

i have the leads you have specified and an ir blaster remote.
however b4 you go further the I.R blaster set top box controller will not learn the codes for my telewest box.

the pc is modern and has s video and all tpyes of connections (it has so many that there is going to be no problem connecting to the pc its connecting to the cable box thats the problem)

the cable box is a pace Di1000t.

my main question is where do i connect out from the digibox? is it the video out scart point where u would normally connect your VCR?

and could the reason the I.R blaster not be learning my remote control be that the remote is damged in someway? (when you start teaching it by pushing the buttons it just recongnizes the channel up then when u push channel down it says u pushed channel up again...it wont get past this point so is my up/down button damaged even though it turns my pace box up/ down?) i have been a cable customer for many many years so my box and remote are old (but still work fine as far as i can tell).

anyways thx for your reply (sorry i posted in multiple forums but i didnt even notice the pc section at first so i just posted in telewest sections).

and if i have all the leads (which i think i do) where do i go next?

17-07-2005, 08:24	#3
xander.uk Inactive Join Date: Jul 2005 Posts: 16	Re: media centre or u.s.b tv card to telewest? hi stewart thx for your reply. i have the leads you have specified and an ir blaster remote. however b4 you go further the I.R blaster set top box controller will not learn the codes for my telewest box. the pc is modern and has s video and all tpyes of connections (it has so many that there is going to be no problem connecting to the pc its connecting to the cable box thats the problem) the cable box is a pace Di1000t. my main question is where do i connect out from the digibox? is it the video out scart point where u would normally connect your VCR? and could the reason the I.R blaster not be learning my remote control be that the remote is damged in someway? (when you start teaching it by pushing the buttons it just recongnizes the channel up then when u push channel down it says u pushed channel up again...it wont get past this point so is my up/down button damaged even though it turns my pace box up/ down?) i have been a cable customer for many many years so my box and remote are old (but still work fine as far as i can tell). anyways thx for your reply (sorry i posted in multiple forums but i didnt even notice the pc section at first so i just posted in telewest sections). and if i have all the leads (which i think i do) where do i go next?