Cable Forum - View Single Post - NTL:home 200 & Netgear MR314 Router

ninebar69 · 09-06-2005, 20:14

Arrrr I see.

I'll pop over and try this tomorrow, and get back to you tomorrow with the results. Hopefully - fingers crossed it will work a treat.

So to recap,

I try the power up adjustments with the laptop 'wired' to the router. If no still no good I'll remove all the authentication settings just leave all as default. Just aquire his MAC address and enter this into the 'clone MAC' settings on the router config page.

I am however asked about the ISP encapsulation settings, these are either Ethernet, PPPoE, PPPTP

I assume I'll just use ethernet as no authentication is required.

Thanks again for your help Paul.

Nik

09-06-2005, 20:14	#7
ninebar69 Inactive Join Date: Jun 2005 Posts: 5	Re: NTL:home 200 & Netgear MR314 Router - NO INTERNET Arrrr I see. I'll pop over and try this tomorrow, and get back to you tomorrow with the results. Hopefully - fingers crossed it will work a treat. So to recap, I try the power up adjustments with the laptop 'wired' to the router. If no still no good I'll remove all the authentication settings just leave all as default. Just aquire his MAC address and enter this into the 'clone MAC' settings on the router config page. I am however asked about the ISP encapsulation settings, these are either Ethernet, PPPoE, PPPTP I assume I'll just use ethernet as no authentication is required. Thanks again for your help Paul. Nik