[jtwn]

I'm trying to get my bios to recognise the speed of my case fans so i can control it through speedfan in windows.

From what i understand you need a 3 wire smartfan, well, my fans have three wires, 2 of them go to the power, and one of them to the the dials on the side of the case (why can't i use these you ask? because the control they give is not enough, neither can i switch them off with that).

Now if i was to cut that wire and put it into the plug which connects the board next to the other 2 pins (the sense pin i think it is) would it work?

Thanks for any replies.