Cable Forum - View Single Post - D-Link 624+ & NTL Cable 200 modem

lspight · 29-01-2005, 21:32

I have a problem !
I've connected to the Internet with the cable modem connected directly to my laptop using an Ethernet cable.
When I move the Ethernet cable from the cable modem to the D-Link 624+ WAN port and run through the wizard the status shows up an NTL IP address only when I use the same MAC address as the cable modem. If the D-Link 624+ uses its own then the status window shows no IP address as if the modem is not connected to the NTL service or not connected to the router.
I can also connect to the D-Link 624+ router admin interface 192.168.0.1
However when I try to connect to an internet site I'm presented with the page cannot be displayed.
The D-Link 624+ has been configured as a DHCP server and my laptop picks up dynamic addresses.
Whats the correct configuration for the 624+ to allow my wireless laptop to connect to it and out onto the laptop with the cable modem?

29-01-2005, 21:32	#1
lspight Inactive Join Date: Jan 2005 Posts: 2	D-Link 624+ & NTL Cable 200 modem I have a problem ! I've connected to the Internet with the cable modem connected directly to my laptop using an Ethernet cable. When I move the Ethernet cable from the cable modem to the D-Link 624+ WAN port and run through the wizard the status shows up an NTL IP address only when I use the same MAC address as the cable modem. If the D-Link 624+ uses its own then the status window shows no IP address as if the modem is not connected to the NTL service or not connected to the router. I can also connect to the D-Link 624+ router admin interface 192.168.0.1 However when I try to connect to an internet site I'm presented with the page cannot be displayed. The D-Link 624+ has been configured as a DHCP server and my laptop picks up dynamic addresses. Whats the correct configuration for the 624+ to allow my wireless laptop to connect to it and out onto the laptop with the cable modem?