View Single Post
Old 12-11-2026, 05:34   #20
homesecurity
Mr Gary Pearce
 
homesecurity's Avatar
 
Join Date: Nov 2026
Location: United Kingdom
Services: TV INternet CCTV Home security Alarms Hikvision Dahua Ajax
Posts: 14
homesecurity is on a distinguished roadhomesecurity is on a distinguished road
Re: 2Gbps now officially available in HFC areas

From the physical cabling and RF infrastructure side, there are two distinct technical realities behind this rollout that explain both the 100Mbps upload bottleneck and the headaches subscribers will hit inside the home:

1. The Physical Return Path Spectrum Barrier (Why Upload is Capped at 100Mbps):
On XGS-PON (pure full-fibre), symmetrical 2Gbps is simple because optical transmission uses separate 1577nm downstream and 1270nm upstream wavelengths with zero RF diplex constraints.
On legacy Hybrid Fibre-Coaxial (HFC), the return path has historically been severely restricted by the physical diplex filters built into street cabinet amplifiers and distribution taps. Most UK cable plants were built on sub-split (5–65MHz) or mid-split (5–85MHz) frequency allocations.
To deliver 2Gbps downstream, VM bonds 31–32 legacy SC-QAM channels alongside a wide DOCSIS 3.1 OFDM block in the upper spectrum (stretching towards 1000–1218MHz). However, the upstream is still crowded into 4 or 5 legacy ATDMA channels plus a narrow OFDMA channel. Until Virgin physically replaces every legacy line amplifier, directional coupler, and street tap across an entire distribution node to High-Split (5–204MHz) or full DOCSIS 4.0 FDX/ESD, squeezing more than 100Mbps upload out of HFC is an RF impossibility without risking severe ingress noise swamping the node.

2. The 940Mbps Local LAN Bottleneck (What Users Actually Experience):
Paul and Carth hit the nail on the head regarding internal home networking. We see this constantly on multi-gigabit upgrades: a customer pays for 2Gbps, runs an online speed test from a PC plugged into a standard wall port or unmanaged gigabit switch, and logs a fault because it tests at "only 930–940Mbps".
Standard Gigabit Ethernet (1000BASE-T) has a hard physical throughput ceiling of roughly 940–948Mbps once TCP/IP framing, inter-packet gaps, and preamble overhead are accounted for.
To actually see 2000Mbps on a single client device:
- The device must connect directly to Port 4 (the dedicated 2.5Gbps port) on the Hub 5.
- The client PC needs a 2.5GbE PCIe network card or USB-C multi-gig adapter.
- Any intermediate switch between the Hub and the PC must be a 2.5Gbps multi-gig switch.
- The interconnecting patch leads and building runs must be solid-copper Cat6 (not cheap flat CCA / copper-clad aluminium cables that suffer from packet loss under heavy multi-gigabit throughput).

3. Latency & Jitter vs Raw Bandwidth:
For gaming, video calling, and interactive tasks, raw bandwidth above 100Mbps is largely irrelevant—packet round-trip time and bufferbloat are what matter. Even with 2Gbps downstream, HFC cable still relies on time-division multiple access on the return path, which inherently introduces more jitter under load than dedicated point-to-point fibre. Putting the Hub into Modem Mode and running a third-party router with SQM (Smart Queue Management such as CAKE or fq_codel) will do infinitely more for real-world responsiveness and game latency than jumping from 1Gbps to 2Gbps on an asymmetrical coax drop.
homesecurity is offline   Reply With Quote