[knack]

Originally Posted by pip08456

When your speed was 'upgraded' all that happened was a new config file was sent to your SH. Nothing else, No change of CTMS, No nothing.

There is no possible place your cable could go via a different route to your neighbour to the CTMS.

Both cables will go via the same ducting to the cabinet and the same way to the CTMS.

Originally Posted by vm_tech

The only way it would have been put onto a new CMTS port is if any type of reseg work occurred beforehand. If it was put onto a new CMTS it would have been done anyway as part of the E6000 upgrade nothing to do with speeds.

---------- Post added at 17:41 ---------- Previous post was at 17:37 ----------



The only way it would take a different route was if you were on the nodal area boundary. I have been on a couple of jobs where the cable has been pulled to the pit to the right of the house rather than left, which was actually fed from a different node.

Basically the feed into your house is RF. Your signal will travel through various bits of coax and through a couple of amps, then back to a fibre node. The fibres run back to the headend/hub site, goes through various splits and conversions to back to RF and it ends up at the CMTS

Originally Posted by MUD_Wizard

There are some diagrams and explanation in this thread:
https://community.virginmedia.com/t5...on/m-p/2260859

Whether you're on an Arris E6000 CMTS now, or still on a Motorola or Cisco, you can find out by googling your CMTS MAC (see your hub stats if you have a hub 3) as has already been suggested.

Thanks all.