Quote:
Originally Posted by G4DDS
I was in my planned recordings and I hit page down twice followed by down 4 times and nothing happened. Just when I thought it had not registered the remote commands the screen updated and it went to the expected place (i.e. two pages down and four programmes down).
It must have took a good 7 or so seconds before the screen update happened but when it did it was one quick succession (i.e. just one single update as apposed to it replaying the commands one-by-one and updating the screen after each one).
|
That sounds like a classic case of NKE5332. It happens because the software gets paged out to the hard drive, and there's a delay whilst it is being paged back in.
Quote:
Originally Posted by G4DDS
|
I can't explain that, but don't rule out IR interference unless you've tested for it. It's very common and can cause quite subtle effects.