I read through this hoping that someone could give some tips on port forwarding but cannot find the answer I was searching for so I would be grateful for any advice on how to set port forwarding/port triggring on the super hub.
Basically my problem began when VM customer services advised me to use the SHUB exclusively for both my ethernet and wireless connections after me reporting that after upgrading to 100MB from 50MB my speed increase had only increase to 57MB.
I was using the SHUB in modem mode only and used my Linksys router for wireless, ethernet and was able to view the images from my AVTECH CCTV system on the local network computers. Although I was reluctant to use the SHUB in full router mode after reading adverse comments on here as to it's shortcomings I gave it a go as my Linksys router, although performing faultlessly was only 10/100 spec and with the 120MB upgrade coming I knew I would never get full speed from it.
Actually, I was quite pleased with the results, even the wireless signal was quite strong but the problem I have is that I am now not able to view images from my security cameras via the ethernet connected AVTECH 4CH MPEG 4 DVR system any more.
I have tried everything that I can to open Port 80 on the SHUB but to no avail and would really appreciate any assistance anyone may be able to offer.
If it is possible I would prefer to carry on using the SHUB but if not then I guess I shall need to upgrade to gigabyte router and go back to using the SHUB in modem mode.
p.s. Even after ditching the Linksys the speed increase was minimal, peking at 64MB.
