View Single Post
Old 11-12-2012, 15:43   #4
jamieas05
Inactive
 
Join Date: Dec 2012
Posts: 2
jamieas05 is an unknown quantity at this point
Re: bush hdmi colour pinout

Quote:
Originally Posted by multiskilled View Post
The way to do it would be to do a continuity test using a multi meter from the good end and put that wire in corresponding pin of the terminal. Here's a link to pin numbers.

http://www.lammertbies.nl/comm/cable/HDMI.html

Be warned though if you get it wrong you could damage your tv and or any other connected device.

My advice would be if your not sure replace the cable even if it's a pain. It could be cheaper in the long run


---------- Post added at 15:43 ---------- Previous post was at 15:39 ----------

Thanks for the advice.
Ive cut the cable and took apart the male connector to see what wires go where.
Ive screwed them in the same places in the screw terminal module, but it still doesn't work!
Any ideas?...............Anyone?
jamieas05 is offline   Reply With Quote