[thenry]

activate the SuperHub following the instructions within the install pack... let it start up. once up and running, top light is blue on the SuperHub put this in your web browser...

192.168.100.1

hit enter and log in, username: admin - password: changeme

at this point you might want to change the settings login password to your choice, I think it'll auto direct you to the change page. this password is to log into your SuperHub and change settings not your wifi password.

once done and saved click on advanced settings below the 3 red boxes if you are not already on the advanced settings page (you'll see a grey column to your left with tabs)

click on modem mode, tick the box and apply

the SuperHub will reboot. straight after you've applied the modem mode setting as its rebooting pull out the ethernet cable linking your SuperHub to your computer and link an ethernet cable from the port nearest to the white cable into rear of the SuperHub to your Apple routers WAN/Internet port and power up the Apple router. make sure you power down the Apple router and power up once linked to your SuperHub

your Apple router settings will be as they were before and you should be connected again