Cable Forum - View Single Post - Problems with new D-Link DIR-645

m8internet · 13-01-2012, 10:44

What was the old D-Link router?
What channel number was it using?
Did you use the same channel number on the new router?
On the new router was Auto Enable Channel Scan on?

How many walls are there between the router and device, before you lose coverage?

Are there any other devices nearby (including neighbours) that could interfere?

The issue with the USB device
It is easier if it is always on, however this is not always possible
As it is being switched on after the router is already on, it will NOT be recognised, with no device connected the port becomes disabled
See page 7
"The router is designed for use with the Ethernet port on your broadband modem. If you were using the USB connection before using the router, you must turn off your modem and disconnect the USB cable. Connect an Ethernet cable to the WAN/Internet port on the router, and then turn the modem back on"
However, if the USB device connects via wireless or port (LAN) it will be recognised
Check to see if this device can be connected via LAN
Sadly my previous printer did not work with a USB - wireless convertor, so I simply replaced it with one capable of WiFi

However this router can be used to view media files, through the USB port
Therefore follow the instructions on page 84, which should keep the USB port active

13-01-2012, 10:44	#3
m8internet Inactive Join Date: Mar 2007 Posts: 187	Re: Problems with new D-Link DIR-645 What was the old D-Link router? What channel number was it using? Did you use the same channel number on the new router? On the new router was Auto Enable Channel Scan on? How many walls are there between the router and device, before you lose coverage? Are there any other devices nearby (including neighbours) that could interfere? The issue with the USB device It is easier if it is always on, however this is not always possible As it is being switched on after the router is already on, it will NOT be recognised, with no device connected the port becomes disabled See page 7 "The router is designed for use with the Ethernet port on your broadband modem. If you were using the USB connection before using the router, you must turn off your modem and disconnect the USB cable. Connect an Ethernet cable to the WAN/Internet port on the router, and then turn the modem back on" However, if the USB device connects via wireless or port (LAN) it will be recognised Check to see if this device can be connected via LAN Sadly my previous printer did not work with a USB - wireless convertor, so I simply replaced it with one capable of WiFi However this router can be used to view media files, through the USB port Therefore follow the instructions on page 84, which should keep the USB port active