Quote:
Originally Posted by teddybear154
I finally got it working. I finally managed to get it to recognise my hard drive after formatting it many times in different formats and did a firmware upgrade. Then I re tuned and could get a picture on all channels. It worked fine the last few days but now I have a new problem. I was watching TV using the Ross free sat last night. Then put it in standby and switched TV off to go to bed. This morning my husband got up and tried to watch the news before going to work and it has completely stopped working. It just says no signal. When you go in to the dish settings it says level 25% quality 0%. I have checked the cable had not come loose and even un screwed it from receiver and re screwed it. I checked the dish had not moved and it hadn't. I checked the rest of cable for any damaged and checked it was connected to Lnb correctly which it was. I then switched the box off and then on again but it made no difference, I have even done a factory reset on the receiver box, But it made no difference. I have a old sky hd box so tried connecting the dish to this but could not get a signal on this either. I don't know if this is because need two cables from dish connected or not. So what could the problem be. Is it most likely another faulty Lnb or do you think the receiver box might be faulty. Has any one else had this problem. IS it worth buying another Lnb to try. Any advice would be much appreciated
thanks in advance
|
When you wired up the system you did seal off the external cable connection with self amalgamating tape or a barrier sealant against inclement weather??