Re: Think Broadband Ping Monitor Results (POST YOURS)
@tdadyslexia
a up dude, seen that mug some where before.
i have noticed since having service suspend a couple of times that my latency was alot worse at peak times when i was on upstream channel 2
Upstream Channels
Lock Status Modulation Channel ID Max Raw Bit Rate Frequency Power
Locked ATDMA 2 20480 Kbits/sec 35800000 Hz 46.7 dBmV
When i am on channel 1 i dont get as bad a peak time latency increase
Upstream Channels
Lock Status Modulation Channel ID Max Raw Bit Rate Frequency Power
Locked ATDMA 1 20480 Kbits/sec 45800000 Hz 45.7 dBmV
being new to cable is there any one within vm that can be spoken to and get a upstream feq change done if my kit starts using channel 2 again?
|