Cable Forum - View Single Post - 50M SuperHub > Draytek Vigor2820n problems

ccarmock · 12-05-2011, 22:44

Also I'd advise to set your WAN 1 port on the Draytek to auto speed & duplex now. Unless you can fix the Superhubs speed too you are likely to get a duplex mismatch. Rule of thumb is fixed both ends or auto both ends but not a combination of the two.

Also I believe you can set the Draytek to NO NAT mode, which would eliminate the double NAT you'd otherwise get.

Of course you'll need to re-enable that again if you use bridge mode on the Superhub when it's available.

12-05-2011, 22:44	#13
ccarmock Inactive Join Date: Jun 2008 Posts: 804	Re: SuperHub > Draytek Vigor2820n problems Also I'd advise to set your WAN 1 port on the Draytek to auto speed & duplex now. Unless you can fix the Superhubs speed too you are likely to get a duplex mismatch. Rule of thumb is fixed both ends or auto both ends but not a combination of the two. Also I believe you can set the Draytek to NO NAT mode, which would eliminate the double NAT you'd otherwise get. Of course you'll need to re-enable that again if you use bridge mode on the Superhub when it's available.