~Im in Belf area, upload speed was due to increase to 3 meg on the 30meg service on the 11th
Had a look at my hub status
Startup Procedure
Procedure Status Comment
Acquire Downstream Channel 299000000 Hz Locked
Connectivity State OK Operational
Boot State OK Operational
Configuration File OK
Security Enabled BPI+
Downstream Channels
Lock Status Modulation Channel ID Max Raw Bit Rate Frequency Power SNR Docsis/EuroDocsis locked
Locked QAM256 78 55616000 Kbits/sec 299000000 Hz 5.3 dBmV 44.9 dB Hybrid
Locked QAM256 79 55616000 Kbits/sec 307000000 Hz 5.4 dBmV 45.4 dB Hybrid
Locked QAM256 80 55616000 Kbits/sec 315000000 Hz 5.3 dBmV 45.4 dB Hybrid
Unlocked Unknown 0 0 Ksym/sec 0 Hz 0.0 dBmV 0.0 dB Unknown
Unlocked Unknown 0 0 Ksym/sec 0 Hz 0.0 dBmV 0.0 dB Unknown
Unlocked Unknown 0 0 Ksym/sec 0 Hz 0.0 dBmV 0.0 dB Unknown
Unlocked Unknown 0 0 Ksym/sec 0 Hz 0.0 dBmV 0.0 dB Unknown
Unlocked Unknown 0 0 Ksym/sec 0 Hz 0.0 dBmV 0.0 dB Unknown
Upstream Channels
Lock Status Modulation Channel ID Max Raw Bit Rate Frequency Power
Locked ATDMA 2 20480 Kbits/sec 45800000 Hz 50.7 dBmV
Unlocked Unknown 0 0 Ksym/sec 0 Hz 0.0 dBmV
Unlocked Unknown 0 0 Ksym/sec 0 Hz 0.0 dBmV
Unlocked Unknown 0 0 Ksym/sec 0 Hz 0.0 dBmV
Primary Downstream Service Flow
Downstream(0)
SFID 6151
Max Traffic Rate 33330000 bps
Max Traffic Burst 3044 bytes
Mix Traffic Rate 0 bps
Primary Upstream Service Flow
Upstream(0)
SFID 6150
Max Traffic Rate 3333000 bps
Max Traffic Burst 8160 bytes
Mix Traffic Rate 0 bps
Max Concatenated Burst 8160 bytes
Scheduling Type Best Effort
I assume from the Max Traffic rate I shold be getting 3meg but i'm not at the mintue
any advice as to what could be causing the issue, I diabled most settings on the hub, firewall etc but cant see what the problem would be.
thanks