View Single Post
Old 15-11-2010, 10:11   #8
Osem
Inactive
 
Join Date: Oct 2006
Location: Right here!
Posts: 22,315
Osem is seeing silvered starsOsem is seeing silvered starsOsem is seeing silvered starsOsem is seeing silvered starsOsem is seeing silvered starsOsem is seeing silvered starsOsem is seeing silvered stars
Osem is seeing silvered starsOsem is seeing silvered starsOsem is seeing silvered starsOsem is seeing silvered starsOsem is seeing silvered starsOsem is seeing silvered starsOsem is seeing silvered starsOsem is seeing silvered starsOsem is seeing silvered starsOsem is seeing silvered starsOsem is seeing silvered starsOsem is seeing silvered starsOsem is seeing silvered stars
Re: Economy 7 Immersion Heater Help.

Surely, where Economy 7 water heating is the sole source of hot water, it's far more demanding on the elements than where an immersion heater is just being used to supplement the hot water provided by, say, a gas boiler. Perhaps not a surprise that the elements need more frequent replacement then?

One other thing. IIRC copper cylinders are supplied with an internal sacrificial anode which is supposed to limit the effects of corrosion inside the tank. Before we had our E7 system ripped out, I noticed the anode inside the cylinder had been completely eroded away over the years and I'm wondering if this is what caused the gradually increased frequency of problems we had with failing elements over time.

The cyclinder we had was a very large on and the hardest part of the job for me was draining it in order to access the elements (hose pipe into cylinder and suction to drain the water). If tradesmen are doing likewsie and charging hourly (which most do) I wouldn't be surprised if they quite like a nice easy immersion heater job...
Osem is offline   Reply With Quote