Cable Forum - View Single Post - Help needed on new sky epg software update

neilboardman · 10-11-2009, 00:25

well this is funny i did a forced update about 10pm it did not work, so I tried another way of doing a forced update which got me the new epg software installed on my box, this is how i have only just got the software installed, first you put your box on standby then take out your viewing card and put it back in but up side down, then keep press the back up button and take out the power lead from behind your box, the next step is to leave the power lead out but keep press the button for ten seconds but make sure you count the ten seconds slowly then insert the power lead back in to the box and then just keep hold of the back up button until you see the four lights come on then it will be doing the update, it could take 10 minutes or longer to finish the update, when the box geos back in standby after the update leave it for five minutes in standby, once you turn your box back on you should have the new epg software, if you do make sure you turn your viewing card over to the correct way, then you are sorted, you must follow these instructions carefully, if you dont do what these instructions tell you to do step by step, you will not get the new epg software installed.

10-11-2009, 00:25	#6
neilboardman Inactive Join Date: Jun 2009 Posts: 27	Re: Help needed on new sky epg software update well this is funny i did a forced update about 10pm it did not work, so I tried another way of doing a forced update which got me the new epg software installed on my box, this is how i have only just got the software installed, first you put your box on standby then take out your viewing card and put it back in but up side down, then keep press the back up button and take out the power lead from behind your box, the next step is to leave the power lead out but keep press the button for ten seconds but make sure you count the ten seconds slowly then insert the power lead back in to the box and then just keep hold of the back up button until you see the four lights come on then it will be doing the update, it could take 10 minutes or longer to finish the update, when the box geos back in standby after the update leave it for five minutes in standby, once you turn your box back on you should have the new epg software, if you do make sure you turn your viewing card over to the correct way, then you are sorted, you must follow these instructions carefully, if you dont do what these instructions tell you to do step by step, you will not get the new epg software installed.