just dont use the VM setup disk, its all just plain ethernet after all.
turn on the CM wait a few until the lights settles, turn on the router and wait a few seconds, turn on your wireless PC device and run its supplyed software (after the above turning off WZC OC)and connect to the wireless router , no VM setup cd required in any of this.
apparently the belkin N1in vista doesnt like working in WPA mode some times so just use WEP instead, but while setting all this up you dont need to use any security, the best advice is turn security all off, getting the kit fully working as you like without it first.
THEN and only then, turn on your wireless security options one at a time to make sure it doesnt break.
and use the wired PC connected to the router to get in and change your settingas you need to, but first read up on it all, there are MANY threads here if you use the search option....
http://kbserver.netgear.com/kb_web_files/n101668.asp
http://kbserver.netgear.com/products/WGR614v9.asp