Thread: Help With PC Build
View Single Post
Old 23-09-2008, 21:28   #15
Dai
Inactive
 
Join Date: Dec 2006
Location: Lincoln UK
Age: 77
Services: 50Mb, TV & Phone
Posts: 3,673
Dai is cast in bronzeDai is cast in bronzeDai is cast in bronzeDai is cast in bronze
Dai is cast in bronzeDai is cast in bronzeDai is cast in bronzeDai is cast in bronzeDai is cast in bronzeDai is cast in bronzeDai is cast in bronzeDai is cast in bronzeDai is cast in bronzeDai is cast in bronzeDai is cast in bronzeDai is cast in bronzeDai is cast in bronzeDai is cast in bronzeDai is cast in bronzeDai is cast in bronzeDai is cast in bronze
Send a message via MSN to Dai
Re: Help With PC Build
Quote:
Originally Posted by David F View Post
honestly it really should not be a problem. The case from the switches are keyed and will tie in with the front panel connector diagram in the manual. The usb will be clearly labeled as vcc + - and ground this will tie in with clearly diagrammed usb headers on the board and in the maunal. The 24 pin power and either 8 pin or 4 pin from the psu will also be clearly shown on the motherboard manual. The only other i can think of is case fans and cpu fan these also will be shown. If you can get all them sorted you should be good to fire it up
LOL.. You've been around too long m8..

If you try *really* hard to think back you might remember when you worried about which way round to put an LED connector..
Dai is offline   Reply With Quote