Quote:
Originally Posted by DombeyBlue
Hi
I am sure this has been discussed before, so I apologise in advance.
I have recently purchased a Dyamode BR-6004 W-G1 802.11 Wireless AP Router from the Virgin website, so I could share my Broadband connection
wirelessly.
My modem is linked to the computer with a USB connection.
I have followed the instructions given with the new router. I don't have any problem getting access to the configuration website (192.168.1.1).
The problem is I do not have any (normal) internet connection. (I hope that makes sense)
If I go into the Control Panel/Network connections, there are two local area connections, one for the Modem and one I guess for the router. The only way I can get a connection to the internet is by disabling the router connection.
I have tried lots of different ways of powering up the system, i.e. Router/modem/PC or modem/Router/PC but nothing works.
I powered up the Laptop, and it looks like it can see the router (it appears as default), it seems like there is a good signal, but it doesn't let me on the the internet.
Sorry if this is all a bit vague, but I am not very computer literate.
Hopefully it is just a case of me doing something wrong, rather than a major issue.
Any help is gratefully received.
Many thanks.
|
Hi
One thing is U have not mentioned about U R ISP, U should mention whether Ur Using ADSL or Cabel Broadband Connection..
k..
I will give u steps for both..
This step is For ADSL Connection, where internet comes from telephone service.. and i assume ur Dynamode router have modem+router
1. Remove the old modem, remove completely USB cabel..
2. Do the physical connection , connect every thing and check the adsl or tel light should be lit up.
3. Configure the router, using ur BB username and password.. and all the info by taking from ISP.
This step is For CABEL Connection, where internet comes from cable line.. and i assume ur Dynamode router is just router, not modem in built.
1. Connect the CABEL modem directly to computer with Ethernet cable..( not with USB cable,completely remove the USB Cable from the modem and as well as from computer)..
if ur abel to go online..u can proceed further to next steps..if not, call our ISP and enable the Ethernet port on the CABEL modem.. once its done..once ur able to go online..proceed to next stpes
2. Connect Cabel modem to wan port and computer to LAN port..
3. Open the configuration page by 192.168.1.1..
4. Configure according to connection type provided by isp..( for cable it will be usually DYNAMIC ) , and u have to clone the MAC add of cable modem..
4. u will be connected and u will be able to go online.. if not
5. Unplug the power cable for the router first and then modem..
6. wait for 30 seconds and put the power cable back to modem and after 30 seconds put the power to router.. router will connect and able to go online
7. If still cant Call Technical Support of dynamode..
Thank you and regards
Vivek N