Quote:
Originally Posted by darthlinux
so let me get this straight I need to switch power on to the router and then connect the cable modem to the ethernet port on pc and leave the router with just the power on is that correct
|
to flash the router do the following
1) Power off the router
2) Disconnect the cable modem from the router
3) The PC that you are going to flash the router
MUST be connected via a network lead to the back of the four port switch on the router
NOT the WAN port
4) Power on the router
Wait for the router to become ready and then perform the flash
To use in normal operation
1) Power of the cable modem and router
2) Power off the router
3) Connect the cable modem to the WAN port on the router using a network cable
4) If you are using a network cable to connect the PC to the router connect it now
5) Power on the cable modem, wait for it to become ready
6) Power on the router, wait for it to become ready
7) Test