View Single Post
Old 05-05-2007, 02:20   #9
Lord Nikon
Inactive
 
Join Date: Jun 2003
Location: NW UK
Posts: 3,546
Lord Nikon has a bronze arrayLord Nikon has a bronze arrayLord Nikon has a bronze array
Lord Nikon has a bronze arrayLord Nikon has a bronze arrayLord Nikon has a bronze arrayLord Nikon has a bronze arrayLord Nikon has a bronze arrayLord Nikon has a bronze arrayLord Nikon has a bronze arrayLord Nikon has a bronze arrayLord Nikon has a bronze arrayLord Nikon has a bronze arrayLord Nikon has a bronze array
Re: Joining Two Component Cables

to my knowlege though it would still be hard to do, if not impossible, VGA spec has seperation of sync feeds, the wii doesn't seem to..

1 Left
2 Right
3 Video
4 +5VDC
5 Ground
6 Ground
7 Y R Luma
8 Mode
9 Pb G Chroma
10 Mode
11 Pr B
12 Ground
13 +12VDC
14 Data Line 1
15 Data Line 2
16 Data Line 3


So pin 3 presumably would be a composite sync feed in RGB mode, you would still need to use a VGA converter box to handle sync seperation for the VGA feed, the component video output from the wii being intended for RGB+Csync for a compatible device.

I stand corrected on my misinterpretation of the component output for the wii, but based on the above pin allocations of the multi AV port on the wii, it would appear my conclusion was still valid
Lord Nikon is offline   Reply With Quote