Quote:
Originally Posted by nopcode
I'm not familiar with ATI control panel, but it does seem like you've managed to set it up to use dual monitors, and the main monitor is the CRT on VGA, so when you change the setting to Digital its trying to change the main monitor (crt) to digital and goes all nice and blank.
Can you find some option to force single screen, (your pc may go blank then) just shutdown pc, unplug the VGA cable, and only leave the DVI cable in.
Then reboot?
Or even try to switch the primary display between 1 + 2
|
In the options it says single display and has the name of my TFT not the crt. I dont see anything to switch between vga and digital.
Quote:
Originally Posted by zinglebarb
Do you get to see post when just connecting with the dvi? if not then its nothing to do with drivers if it is it could and simple way to test is to uninstall drivers and the control center reboot pc with dvi connected and reinstall drivers this will just use dvi. If you do see post when just using dvi you should be able to boot to safe mode
|
I cant see anything when just connected via dvi.
---------- Post added at 04:34 ---------- Previous post was at 04:29 ----------
i even tried resetting factory defaults in the catalyst control panel and nothing. will try connecting the crt monitor again and see if i can figure something out