[DragonRebornUK]

Status Page
Task Status
Acquire Downstream Channel Done
Obtain Upstream Parameters Done
Establish IP Connectivity using DHCP Done
Establish Time Of Day Done
Transfer Operational Parameters through TFTP Done
Register Connection Done
Cable Modem Status Operational
Initialize Baseline Privacy Skipped

Signal Page
Downstream Value
Frequency 331000000 Hz Locked
Signal to Noise Ratio 33 dB
Power Level 8 dBmV
The Downstream Power Level reading is a snapshot taken at the time this page was requested. Please Reload/Refresh this Page for a new reading

Upstream Value
Channel ID 3
Frequency 29200000 Hz Ranged
Power Level 49 dBmV

Address Page
Skipped too much private info!

Config Page

Frequency Plan: European PAL I/B/G
Upstream Channel ID:3
Frequency (Hz):311000000
Enable DHCP Server
The SURFboard cable modem can be used as a gateway to the Internet by a maximum of 32 users on a Local Area Network (LAN). When the Cable Modem is disconnected from the Internet, users on the LAN can be dynamically assigned IP Addresses by the Cable Modem DHCP Server. These addresses are assigned from an address pool which begins with 192.168.100.11 and ends with 192.168.100.42. Statically assigned IP addresses for other devices on the LAN should be chosen from outside of this range

Note:
Resetting the cable modem to its factory default configuration will remove all stored parameters learned by the cable modem during prior initializations. The process to get back online from a factory default condition could take from 5 to 30 minutes. Please reference the cable modem User Guide for details on the power up sequence.

Help Page
Software Version: SB4100-0.4.9.6-SCM01-NOSH
Hardware Version: 0
MIB Version: II
GUI Version: 1.0
VxWorks Version: 5.3

Will PM the address page if needed mate. Nowt on there about downloads uploads. just macs and ips

Cheers

Matt