Quote:
Originally Posted by KevAmiga
If your Pace STB is stuck on "TUNE", power down, hold down key and power up. Once display says "BOOT" release down key. STB will take a while to boot but sometimes this can save an engineer by hard-resetting the STB.
|
Had this very problem for the first time tonight. After a few hours of frustration was about to follow The Damned's advice and "Smash It Up"... then remembered to try this forum. Low and behold... The Cure.... a partial cure anyway. It now progresses beyond "TUNE" to a message that says the channels are currently unavailable "may be due" to my cable becoming unplugged. I've checked connections already so it's not looking good. All the same.. I appreciate the tip.... TNX