Cable Forum - View Single Post

tomroyal · 29-09-2006, 15:14

Hmm - well, the box just got updated. It went dead, then displayed "pdld / errs / LA1t / errs" a few times. Then another restart, and a few minutes stuck on channel 400 while the cable modem came up. Finally, a message saying that the software was being updated.

So, it's no longer stuck on "starting", and I can select any channel I like via the new numbers. Unfortunately, they're all blank and there's no schedule information. Anyone else having better luck?#

Edit - NTL support says that the update "might not be finished" and that when it has, the channels "should start to reappear gradually", so to give it a few hours. Sounds unlikely, but there you go.

29-09-2006, 15:14	#36
tomroyal Inactive Join Date: Feb 2006 Posts: 19	Re: STB stuck on "starting" Hmm - well, the box just got updated. It went dead, then displayed "pdld / errs / LA1t / errs" a few times. Then another restart, and a few minutes stuck on channel 400 while the cable modem came up. Finally, a message saying that the software was being updated. So, it's no longer stuck on "starting", and I can select any channel I like via the new numbers. Unfortunately, they're all blank and there's no schedule information. Anyone else having better luck?# Edit - NTL support says that the update "might not be finished" and that when it has, the channels "should start to reappear gradually", so to give it a few hours. Sounds unlikely, but there you go.