Quote:
|
Originally Posted by iklebrit
im using the latest 3com drivers set up as follows
802.1p =disabled <-- have no idea what this is for??
down poll rate = 8 <-- have no idea what this is for??
flow control = enabled <-- have no idea what this is for??
Media type = 10Mb half duplex
Rx checksum offload = disabled <-- have no idea what this is for??
Tx checksum offload = disabled <-- have no idea what this is for??
when im using edonkey it says im downloading at say 40, so theres theoretically 30KB/sec left to use, but when i click on a link in explorer it seems to hold for a few seconds then the page loads.
|
Firstly,I've had a look at 802.1p seems to be for polling and prioritizing traffic. 802.1 generally is the group for LAN management.
Secondly, try using full duplex and seeing if that speeds it up, it should. If you are going to test the speed use a speed test like
Robin's or
ADSL Guide's.
HTH