Question : Routers and LAN IP addresses
 

Hi

I am new here so hello to everyone..

I have a question -

I want to connect my LAN of two PC's that use static IP addresses that I have made up to the internet (via cable modem).

I want to keep my static IP addresses - will this be possible if I use a router as a a go-between between the cable modem and my PC's?

Many thanks for any help.

Re: Question : Routers and LAN IP addresses
 

:welcome: to Cable Forum :D

In theory yes. You will need to find a configuration setting in the router that allows you to change the default LAN IP range settings of the router. The router's range will need to be the same of you network.

You will also need to set the router LAN IP as a gateway in each workstation's IP settings so as to get out onto the internet.
__________________

However, to avoid confusion, you probably do not want the IP range of your LAN, to be in the same range as the IP issued by the modem to the router's WAN port.

Re: Question : Routers and LAN IP addresses
 

Thanks for the quick response

As for my static IP's on my 2 PC's - that can be anything as long as they are static. I mean I don't have a problem changing them to any other IP as long as it is static.

Re: Question : Routers and LAN IP addresses
 

In whcih case it's even easier to setup. Plug in your router and reboot modem and router. Connect your PCs, set the IP on the PCs to the same as the router LAN range, together with adding the gateway and that should be it.

Re: Question : Routers and LAN IP addresses
 

:welcome: Welcome to the Cable Forum.Hope this link helps:

http://www.digitmag.co.uk/forums/msg...forum=2&tz=-60

Re: Question : Routers and LAN IP addresses
 

One last question, will the fact that my ISP uses DHCP to assign addresses interfere with my plans for the network I described above?

Again, thanks for so many reponses.
:)

Re: Question : Routers and LAN IP addresses
 

Your router will pick up the assigned address from the modem as it's WAN port. That will be transparent to you.

Your LAN side can do whatever you need it to, independent of your ISP.

Re: Question : Routers and LAN IP addresses
 

Yes, you would turn the dhcp server off on the router, change the router IP to be in the same range as your two static IPs and you should be golden.

Re: Question : Routers and LAN IP addresses
 

Great. This has answered all my questions.

You guys are the dogs b*ll*cks.

Re: Question : Routers and LAN IP addresses
 

Thing is, with most routers, if there are only the two items (or more on the LAN) then the IP will remain static anyway.
My Linksys WRT54G had a device connected to it that had not been connected for about 4 months. At the time it had two devices connected and allocated to 192.168.1.100 and 101, despite the time the device was allocated to 106, the IP allocated previously.

You don't need to turn the DCHP server in the router off though if the PC has a manual address set, just make sure you don't allocate in the DCHP range. For linksys this is by default 100-150, so anything below this can be static (and / or you can change the dynamic range).