![]() |
Network or Router Fault?
Ok guys
I have a connection with VM and an adsl with TT here the stats from both adsl http://www.thinkbroadband.com/ping/s...18-05-2012.png cable day before [img]Download Failed (1)[/img] last night http://www.thinkbroadband.com/ping/s...06-06-2012.png adsl is for about 1 month and seems very stable and always like that in the graff's monitor cable last few days seems very congested example untill 8 pm (at monitor last night's graff) few other days with cable was worst lately However i reset the SH then it wont synchronise i had to reset 4-5 times when finally it did as you see from monitor after 9 pm jitter it gone massive down and got for first time jitter 0 with VM http://www.pingtest.net/result/64133778.png SH is with modem mode and i use a vigor 2850n (which i have not reset but i reboot it) So after 8-9pm (SH was reset) and adsl connected back to build in vigor's modem Now the adsl has got the jitter (lot of yellow) and the cable connection is much less yellow http://www.thinkbroadband.com/ping/s...07-06-2012.png Any one knows what is going On could be the draytek vigor or network really???? Thanks |
Re: Network or Router Fault?
Check if any of your IP's have changed
|
Re: Network or Router Fault?
the IP address of virgin media have changed with SH alone but when i connect to the vigor is coming back the same old one
also the Talk Talk has change as well because they use dynamic |
Re: Network or Router Fault?
Set up some new graphs and see how that looks
|
Re: Network or Router Fault?
before was not much yellow, now it is even with idle connection
http://www.thinkbroadband.com/ping/s...07-06-2012.png now the opposite vm congestion seems nothing & before was full yellow and packet loss http://www.thinkbroadband.com/ping/s...07-06-2012.png |
Re: Network or Router Fault?
I think you may have misunderstood my point, double check that the IP address's being used by the Think broadband ping monitor's are still correct.
I suspect with all your rebooting that your devices are now using different IP addresses and therfore the information you are now seeing is basically someone elses connection. So start some more from scratch if your not sure what I mean |
Re: Network or Router Fault?
thanks for reply
all Ip addresses from TBB monitor are correct with the ones now will go work soon but will try later some other 2850n firmware which some users at draytek forums states will synchronise better with less errors and less line attenuator |
Re: Network or Router Fault?
In that case I wouldn't worry too much, your virgin monitor now looks respectable and your TT aint too bad. Yes the TT one shows some large spikes which I would hazard a guess at usage somewhere on your network.
I would leave things alone for a bit and see if it sorts itself out |
Re: Network or Router Fault?
hmmmm you properly right about TT
last night i got disconnected from TT and phone line was dead as well so i guess they doing some kind of work at exchange or TT LLU side(no cabinet for me,is direct line) so i will leave thinks as it is and see how will turn up(follow your advise) THANK YOUUUU |
Re: Network or Router Fault?
Makes sense
Your welcome |
All times are GMT +1. The time now is 17:25. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
All Posts and Content are © Cable Forum