Frequently not getting 50M through wired connection
 

I have the 50MB service, but do not always get 50mb speed recently. I'm not worried about wireless speeds, just wired connection.
I have a Belkin N1 vision wireless router connected to my cable modem. Cabled into that I have a NAS and a few other devices, also a long Cat 5 cable which goes outside the house and back into another room where I have a 5 port Cisco switch with a Wireless access point, Apple TV and my Macbook.
My Macbook recently doesn't get 50MB (it used to regularly), it gets average 25-35MB speeds.
If i plug the Macbook directly into the Virgin modem I get 50MB.
If i plug the Macbook directly into the Belkin, then I get reduced speed again, occasionally 50MB, and when I plug into the Cisco i rarely get 50MB these days, it's very hit and miss.
Do you think some of my other devices are taking the bandwidth? I have a QNAP Turbo NAS, but i'm wondering if it's the Belkin that's causing issues...
any help or sugggestions greatly appreciated!

Re: Frequently not getting 50M through wired connection
 

Belkin is not a manufacturer/supplier renowned for quality products :(

Of course it could be dying but check it's config to make sure that nothing untoward has got inadvertainly set. Pay partiular attention to QOS if it is an available option.

Re: Frequently not getting 50M through wired connection
 

Hmm I had the feeling that my Belkin was not up to scratch... I've had it for a good few years as well.
Are the Super hubs that come from Virgin any good?

Re: Frequently not getting 50M through wired connection
 

In one word.......No

Imagine the worst router you can get and times it by a million. The shub is worse than that :)

Re: Frequently not getting 50M through wired connection
 

Fair enough. Super Hub a no-no then.
Incidentally I found no QoS options on the Belkin.

Can anyone recommend suitable routers? Must have gigabit ports, and be able to
cope with the imminent 100mb upgrade to broadband service.

I was looking at the Linksys E range of routers.

Re: Frequently not getting 50M through wired connection
 

good choice dude. I had the wrt150N when i was on 50mbit and upgraded to the E3000 for 100mbit. It is an excellent router with great wireless range and performance. The E2000 also has gigabit ports but it isnt dual band

Re: Frequently not getting 50M through wired connection
 

Hi There, I am new to the forum and even though im not currently a Cable customer, i did use to work for Virgin Media Broadband Tech Support at one point.

One thing in the below quote struck me and i thought i would register and post my answer to you. The Cat 5/5e/6 cable you have is it UTP (unshielded Twisted Pair) or STP (Shielded Twisted Pair) to check this read the cable itself or try a different cable.

The reason i mention this is because UTP Ethernet cable is UNSHIELDED and can be succeptable to interference from outside influences such as wireless, mobile phones, microwaves, Taxi Cabs, CB radios and so on so this would probably cause a hinderence in the performance anyway on top of any issues with this router.

I would probably suggest running a Power Line system instead, it utilises your existing home electric system as a method to send data Up/down (e.g. it sends the internet though your 3 Pin Power Plug)

You can get decently priced ones on here http://www.7dayshop.com and search Power Line at the top of the page!

Anyway hope this helps also.

Re: Frequently not getting 50M through wired connection
 

LMAO. Interference on an ethernet cable but not mains electric? Get real.

Re: Frequently not getting 50M through wired connection
 

Thanks for the suggestions, but I have already tried a Powerline solution, with not great results for network speed - nowhere near the 1000Mbps promised, and kept cutting out too...

My cable that runs between rooms outside is UTP, so perhaps I should try a shielded cable instead.

Re: Frequently not getting 50M through wired connection
 

Haha indeed, i'd expect the interference from mains to be a hell of a lot more than anything you could get through an unshielded Ethernet cable.