Belkin Wireless Router set up problem
 

I have a Belkin FSD7230V4 wireless router connected to a Terayon NTL Modem.
I have had trouble over the last few weeks with thwe router needing a reboot after failure. I upgraded to the latest UK f/w.

Now the router wont work at all (the NTL modem link is fine.
The network is set up for dynamic connection with server defined ip addresses.

When i run the router set up program i select dynamic connection type but when I get to the router config page it is asking for ip addresses etc.

I have got the server and alternate server ip adresses from NTL support but cannot use this to complete set up page

Can anyone help

Harry H

Re: Belkin Wireless Router set up problem
 

Moved your thread from the articles section (which is reserved for reference articles), into the main forum which is for questions.

Have you tried a hard reset? Normally there is a little button hidden somewhere you need to press with a pen or needle.

Re: Belkin Wireless Router set up problem
 

Yes I have tried that, when I eventually found the hole

Re: Belkin Wireless Router set up problem
 

I have with the expert assistance of Belkin Support fixed the problem which involved the following steps ( not necessarily in this order)
Did a router reset via the hole at the back of the router.
Got the belkin set up screen using the browser 192.168.2.1
I did have to set the home page to blank to stop google for interfering.
Using WAN Mac Address - Clone

Then to check START cmd
then IPCONFIG
then PING 192.168.2.1
The last two show whether you have succeeded in the previous steps.

Re: Belkin Wireless Router set up problem
 

My neighbour had a similar problem, and resolved by the above steps. Seemed a bit odd to me, that it worked fine for ages, then stopped. By cloning the mac address all was fine afterwards.