![]() |
Ready Light Flashing
Hi, about 6 weeks ago had a problem in which the ready light kept flashing on my ntl cable modem, if you powered the modem down that would resolve it, sometimes for 5 mins sometimes for an hr or so. In the end I rang ntl and after hrs on the phone they finally sent out an engineer who replaced the modem. It seemed to be fine for about 2 days but now and then over the last 6 weeks since then it does the same but by removing the power cable AND the NTL cable it resolved the problem for longer periods of times.
However over the last week it has got worse than ever, the ready light constantly flashes and when removing both the cables (just the power isnt good enough) it fixes itself for about 10 minutes, then starts flashing. On some occasions both the ready light and the sync light go out completely. I really do not want to have to call the support line again. Here are some stats...any ideas? Downstream Status: Downstream Frequency : 402750000 Hz Downstream Receive Power Level : -4.1 dBmV Downstream SNR : 31.4 dB Upstream Status: Upstream Transmit Power Level : 61.0 dBmV Upstream Symbol Rate : 2560 Ksym/sec Upstream Frequency : 22000000 Hz ALso in the event log got things like this: FRI JUN 10 17:17:37 2005 No UCD's Received - Timeout MON JUN 13 10:30:42 2005 DHCP FAILED - Discover sent, no offer received WED JUN 15 16:16:28 2005 Received Response to Broadcast Maintenance Request, But no Unicast Maintenance opportunities received - T4 timeout MON JUN 13 10:32:03 2005 TFTP Failed - OUT OF ORDER packets SYNC Timing Synchronization failure - Failed to acquire QAM/QPSK symbol timing SYNC Timing Synchronization failure - Failed to acquire FEC framing THU JUN 16 20:40:55 2005 Link up--Cable interface Link down--USB interface Thanks |
Re: Ready Light Flashing
hi :welcome: to the site
by the looks ur Upstream Transmit Power Level is a bit high taken from here http://homepage.ntlworld.com/robin.d...ps/signal.html "The upstream transmit power will lie within the range +8 to +58 dBmV" but some will comfirm this but u need to call ntl but perhaps some1 here from ntl maybe able to help u. iain hope u enjoy ur stay. |
Re: Ready Light Flashing
I have the problem with the RDY light as well. Most of the time, the SYNC light doesn't show either. I phoned up NTL and it is apparently an area problem (in ST16).
|
| All times are GMT. The time now is 21:39. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
All Posts and Content are © Cable Forum