![]() |
Far infra red heating
I'm building a single story 4x4m kitchen/diner extension off the back of my house. It will incorporate one of the back downstairs rooms that will have its back external wall removed so that the whole room is a continuous 8x4 space, about half of which will be glass walled (folding/sliding doors).
The builders quotes have come in rather high and I'm looking to shave off some of the cost. I was hoping for wet underfloor heating but thats one of the few areas where I can make a considerable saving so I am looking at alternatives. I have discounted electric underfloor heating as too expensive to run. I could simply put another rad in the new room to augment the existing one but they take up space so I'd rather not. By chance I came across infra red heating panels at a local showroom but they seem too good to be true, hence I'm asking you lot for your thoughts. The panels can be disguised to look like a mirror or a picture, or simply part of the ceiling. Running costs are claimed to be about 3p/hr on average! Link to how they work:http://www.glassheating.com/informat...ks-information More blurb: http://www.lava-designs.com/en/das-produkt-lava-en/ My experience in life is that if something seems too good to be true then it generally is but I simply can't find a downside to this method of heating a room. Anyone know any different? :confused: |
Re: Far infra red heating
At the end of the day, energy input = warmth. Whatever method you use, be it radiator, underfloor, infra red, your room will need a certain level of energy to keep it warm. So it's not about how much per hour, it might cost, but how many of those panels you might need for the space.
Your extension, compared to the rest of the house, being modern construction should be quite well insulated, reducing heat losses. Indeed it's quote possible that even wiht the extension, you don't need that much more heat input to keep the area warm, than for the existing room. But those folding doors, even double glazed could mess that up. Underfloor heating is only efficient if you have loads of insulation under the entire floor. Personally I'd be sticking with a radiator, remember you don't have to have a horizontal one, there are plenty of attractive vertical designs. Even your infra red panel is going to use some wall space. |
Re: Far infra red heating
I'll just pop over to the supplier and ask how many panels I'd need for the space.
The extension will be very well insulated, in fact building control passed the plans first time round. One of the reasons for the cost of the wet undrfloor install is that the back room would have to be excavated (concrete floor) to about 1ft depth in order to allow for the shedload of insulation. I'd be looking to fit the panels to the ceiling..... ---------- Post added at 09:37 ---------- Previous post was at 08:57 ---------- Looks like I'd need panels that would cost about 12p/hr to run in a room that size......and they wouldn't need to be on all the time......purchase cost would be in the region of £500-£700, install cost negligable. I have asked to be put in contact with existing customers/users to get their opinions. :D |
Re: Far infra red heating
Quote:
Personally i would go with Robs suggestion and plumb another radiator into your existing system the cost will be much lower with very little extra running cost |
Re: Far infra red heating
Why not get a double rad to replace the one you already have?
|
Re: Far infra red heating
Quote:
|
Re: Far infra red heating
I can't remember what they are called but you used to be able to get long thin rads with fans in them for wall mounting just below ceiling height.
|
Re: Far infra red heating
Quote:
|
Re: Far infra red heating
Quote:
|
Re: Far infra red heating
Ah, I was thinking of the electric ones.....
|
Re: Far infra red heating
The only number you should care about is efficiency, i.e. how many watts of heat does it produce for how many watts of gas/electric input.
|
Re: Far infra red heating
Quote:
It's touted as being economical & eco-friendly........but then so is solar pv :dozey: |
Re: Far infra red heating
There is no such thing as environmentally friendly, unless you are getting that heat source from a totally renewable source that doesn't combust, and even then there will be the resources used to create the heating appliance.
What we should be talking of is efficiency. In part that can relate to how the heat is distributed. Radiators and other convectors will see warmer air rising. Fans might be used to push air around, however the overall effect is often cooler temperatures at the bottom of a room, just where everyone is lounging about. That is compounded if you have high ceilings. Underfloor works by having an even heat spread around a room, at lowish temperatures and because your toes are warm, most people feel that is more comfortable. But it can take a while to get the system going, and will be unresponsive, as the structure of the floor has to first be heated before that heat spread into the room. Conversely that structure latent heat can help to create a balance. But if only one room in a house is heated this way, how easily that balance can be achieved is uncertain. As the lined to diagrams show the infra red might seem better and more efficient, at least for some people, as the heat is reflected around a room, but that will also depend on where the panels are located. If the panels are high up, or ceiling mounted you might feel like your head is being cooked and yet that reflected heat hasn't got down to your feet? |
Re: Far infra red heating
Quote:
One of the things I did get the salesman to admit to was that these panels work best on 'normal' height ceilings, rather than high ceilings......so thats a plus. I was wondering about the 'cooked head' thing myself. They look perfect for the job otherwise.....I need input from people who have used these things so I'm hoping they contact me soon. ---------- Post added at 16:27 ---------- Previous post was at 16:17 ---------- From Wikipedia: Quote:
|
Re: Far infra red heating
So based on that wikipedia article unless your body is in the target area of the panel it's going to be cold, as the room's air temperature will be cooler, and it probably will be the case that the side facing the heater will be warm and the other side cool. You might need to put your furniture on a turntable so you cook yourself evenly :erm:
|
| All times are GMT. The time now is 10:03. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
All Posts and Content are © Cable Forum