Cable Forum

Cable Forum (https://www.cableforum.uk/board/index.php)
-   Virgin Media Internet Service (https://www.cableforum.uk/board/forumdisplay.php?f=12)
-   -   Scientific Atlanta 2100 With VM (https://www.cableforum.uk/board/showthread.php?t=33620237)

CIS 30-08-2007 15:29

Scientific Atlanta 2100 With VM
 
I got VM 20mb installed and also got a free Scientific Atlanta 2100 Cable modem. (is this modem any good!?)

My question is this (if you would be so kind) is there a direct route into admin panel (like with ADSL routers) you know an ip entry 192.168.1.1 ?

I don't seem to see one.

Also it comes up sometimes that Local Area Connection is disconnected and then connects again about a min later, I have checked all wires and everything is working ok with the pc, is this just the modem or is this common?

Thank you.
CIS

synner 30-08-2007 15:54

Re: Scientific Atlanta 2100 With VM
 
Hi CIS,

First off, welcome aboard !

You can reach the 2100 admin panel by navigating to http://192.168.100.1

As for the disconnections, I've not had that problem, it could be that your modem is dropping sync, once you've got to the admin pages check the logs.

HTH

Bri

CIS 30-08-2007 17:52

Re: Scientific Atlanta 2100 With VM
 
Thank you for the reply Synner

The logs look like this, I take it this is not a good thing.

Thu Aug 30 14:31:38 2007 Critical (3) DHCP WARNING - Non-critical field invalid in response.
Thu Aug 30 14:31:31 2007 Critical (3) No Ranging Response received - T3 time-out
Thu Aug 30 14:31:21 2007 Critical (3) Unicast Ranging Received Abort Response - Re- initializing MAC
Thu Aug 30 14:31:02 2007 Critical (3) No Ranging Response received - T3 time-out
Thu Aug 30 14:30:28 2007 Critical (3) Unicast Ranging Received Abort Response - Re- initializing MAC
Thu Aug 30 14:30:11 2007 Critical (3) No Ranging Response received - T3 time-out
Thu Aug 30 14:28:59 2007 Critical (3) Unicast Ranging Received Abort Response - Re- initializing MAC
Thu Aug 30 14:28:42 2007 Critical (3) No Ranging Response received - T3 time-out
Thu Aug 30 14:28:28 2007 Critical (3) Unicast Ranging Received Abort Response - Re- initializing MAC
Thu Aug 30 14:28:09 2007 Critical (3) No Ranging Response received - T3 time-out
Thu Aug 30 14:27:41 2007 Critical (3) Unicast Ranging Received Abort Response - Re- initializing MAC
Thu Aug 30 14:27:17 2007 Critical (3) No Ranging Response received - T3 time-out
Thu Aug 30 14:26:50 2007 Critical (3) Unicast Ranging Received Abort Response - Re- initializing MAC
Thu Aug 30 14:26:27 2007 Critical (3) No Ranging Response received - T3 time-out
Thu Aug 30 14:26:05 2007 Critical (3) Unicast Ranging Received Abort Response - Re- initializing MAC
Thu Aug 30 14:25:45 2007 Critical (3) No Ranging Response received - T3 time-out
Thu Aug 30 14:25:16 2007 Critical (3) Unicast Ranging Received Abort Response - Re- initializing MAC
Thu Aug 30 14:24:53 2007 Critical (3) No Ranging Response received - T3 time-out
Thu Aug 30 14:24:40 2007 Critical (3) Unicast Ranging Received Abort Response - Re- initializing MAC
Thu Aug 30 14:24:14 2007 Critical (3) No Ranging Response received - T3 time-out
Thu Aug 30 14:23:01 2007 Critical (3) Unicast Ranging Received Abort Response - Re- initializing MAC
Thu Aug 30 14:22:44 2007 Critical (3) No Ranging Response received - T3 time-out
Thu Aug 30 14:22:24 2007 Critical (3) Unicast Ranging Received Abort Response - Re- initializing MAC
Thu Aug 30 14:21:59 2007 Critical (3) No Ranging Response received - T3 time-out
Thu Aug 30 14:21:25 2007 Critical (3) Unicast Ranging Received Abort Response - Re- initializing MAC
Thu Aug 30 14:21:06 2007 Critical (3) No Ranging Response received - T3 time-out
Thu Aug 30 14:29:58 2007 Critical (3) SYNC Timing Synchronization failure - Failed to acquire FEC f...
Thu Aug 30 14:20:52 2007 Critical (3) Unicast Ranging Received Abort Response - Re- initializing MAC
Thu Aug 30 14:20:25 2007 Critical (3) No Ranging Response received - T3 time-out
Thu Aug 30 14:20:13 2007 Critical (3) Unicast Ranging Received Abort Response - Re- initializing MAC
Thu Aug 30 14:19:49 2007 Critical (3) No Ranging Response received - T3 time-out
Thu Aug 30 14:19:40 2007 Critical (3) Unicast Ranging Received Abort Response - Re- initializing MAC

synner 30-08-2007 18:06

Re: Scientific Atlanta 2100 With VM
 
Hi,

Some of the items in your logs look normal, heres mine:

Time Not Established Critical (3) DHCP WARNING - Non-critical field invalid in response.
Tue Aug 28 17:02:52 2007 Critical (3) Resetting the cable modem due to docsDevResetNow
Time Not Established Critical (3) DHCP WARNING - Non-critical field invalid in response.
Time Not Established Critical (3) No Ranging Response received - T3 time-out
Time Not Established Critical (3) DHCP FAILED - Discover sent, no offer received
Time Not Established Critical (3) No Ranging Response received - T3 time-out
Time Not Established Critical (3) DHCP FAILED - Discover sent, no offer received
Time Not Established Critical (3) No Ranging Response received - T3 time-out
Time Not Established Critical (3) SYNC Timing Synchronization failure - Failed to acquire FEC f...
Time Not Established Critical (3) DHCP FAILED - Discover sent, no offer received
Time Not Established Critical (3) No Ranging Response received - T3 time-out
Time Not Established Critical (3) DHCP WARNING - Non-critical field invalid in response.
Time Not Established Critical (3) No Ranging Response received - T3 time-out
Time Not Established Critical (3) DHCP WARNING - Non-critical field invalid in response.
Time Not Established Critical (3) No Ranging Response received - T3 time-out
Time Not Established Critical (3) Resetting the cable modem due to console command
Time Not Established Critical (3) SYNC Timing Synchronization failure - Failed to acquire QAM/Q...
Time Not Established Critical (3) Resetting the cable modem due to console command

Not sure about this though: Thu Aug 30 14:24:40 2007 Critical (3) Unicast Ranging Received Abort Response - Re- initializing MAC

Post your signal details, may give us more clues..

Bri

{FU}Fubar 30-08-2007 18:07

Re: Scientific Atlanta 2100 With VM
 
my logs look alot like that too

Time Not Established Time Not Established
1

Critical(3)

68000300
DHCP WARNING - Non-critical field invalid in response.
Time Not Established Time Not Established
2

Critical(3)

82000200
No Ranging Response received - T3 time-out

CIS 30-08-2007 18:15

Re: Scientific Atlanta 2100 With VM
 
Downstream Status Operational
Channel ID 7
Downstream Frequency 339000000 Hz
Modulation 256QAM
Bit Rate 20480000 bits/sec
Power Level -5.6 dBmV
Signal to Noise Ratio 40.7 dB


Upstream Status Operational
Channel ID 3
Upstream Frequency 37500000 Hz
Modulation 16QAM
Bit Rate 768000 bits/sec
Power Level 61.0 dBmV

The speeds thus far have been great.

synner 30-08-2007 18:23

Re: Scientific Atlanta 2100 With VM
 
Hi,

Lucky you ! My speeds are all over the place, not had anything over 15Mb/s yet... ah well...!

I'm a little concerned about your upstream power level, looks a little high to me, mines at 41dBmv.

Hopefully someone else will confirm/deny..

Bri

monkey2468 30-08-2007 19:10

Re: Scientific Atlanta 2100 With VM
 
Quote:

Originally Posted by CIS (Post 34386703)
Downstream Status Operational
Channel ID 7
Downstream Frequency 339000000 Hz
Modulation 256QAM
Bit Rate 20480000 bits/sec
Power Level -5.6 dBmV
Signal to Noise Ratio 40.7 dB


Upstream Status Operational
Channel ID 3
Upstream Frequency 37500000 Hz
Modulation 16QAM
Bit Rate 768000 bits/sec
Power Level 61.0 dBmV

The speeds thus far have been great.

Its probably dropping its connection as the upstream power levels is V. high.

CIS 30-08-2007 20:42

Re: Scientific Atlanta 2100 With VM
 
How do I go about lowering the upstream power level (mind you, the connection has not dropped in a few hours) and the level is now at - 59.5 dBmV

fatassmichael 30-08-2007 21:19

Re: Scientific Atlanta 2100 With VM
 
you will need a tech out to alter power from the cab

CIS 30-08-2007 23:31

Re: Scientific Atlanta 2100 With VM
 
It has not disconnected in a while now (hours) and I have been on it all day. So I think I will just leave it and maybe get tech out if I have any big problems, because the speeds are flying, my downloads today have not dropped below 2500.0 Kbytes/s (2.5MB/Sec) and I am pulling a 600mb file down in 5 mins.

Thanks for all the support. very nice of you all.

evilmonkey 31-08-2007 11:49

Re: Scientific Atlanta 2100 With VM
 
Quote:

Originally Posted by CIS (Post 34387010)
It has not disconnected in a while now (hours) and I have been on it all day. So I think I will just leave it and maybe get tech out if I have any big problems, because the speeds are flying, my downloads today have not dropped below 2500.0 Kbytes/s (2.5MB/Sec) and I am pulling a 600mb file down in 5 mins.

Thanks for all the support. very nice of you all.

You still realy need to get that upstream power level attenuated. Should be below 58 and above 30 to function normally.

CIS 31-08-2007 12:21

Re: Scientific Atlanta 2100 With VM
 
No choice now, as the internet connection died a death this morning, I put the pc on, did a speed test (20meg flying) went to load up a webpage and nothing, from that the cable light was flashing and then just went out. No upstream at all and the down rate was on -17, also no mac address, bla bla

So I called tech support and they are sending an engineer out tomorrow to take a look see, but from what I can make out, a lot of people are having a lot of problems.

evilmonkey 31-08-2007 12:35

Re: Scientific Atlanta 2100 With VM
 
Quote:

Originally Posted by CIS (Post 34387324)
No choice now, as the internet connection died a death this morning, I put the pc on, did a speed test (20meg flying) went to load up a webpage and nothing, from that the cable light was flashing and then just went out. No upstream at all and the down rate was on -17, also no mac address, bla bla

So I called tech support and they are sending an engineer out tomorrow to take a look see, but from what I can make out, a lot of people are having a lot of problems.

If possible try to ensure the engineer doesnt just swap the modem or add an attenuator to the back of the modem. He will need to make his adjustments from the cabinet to make them perminent.

CIS 31-08-2007 14:18

Re: Scientific Atlanta 2100 With VM
 
Quote:

Originally Posted by evilmonkey (Post 34387335)
If possible try to ensure the engineer doesnt just swap the modem or add an attenuator to the back of the modem. He will need to make his adjustments from the cabinet to make them perminent.

Thanks for the good advice.

Just so I can get it right, what is the cabinet. is it the small white box on the inside of the room, where the cable enters the house?

So I can take a look on the day and see if he goes near it.


All times are GMT +1. The time now is 23:53.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
All Posts and Content are © Cable Forum