Cable Forum - Audio interferance

Cable Forum (https://www.cableforum.uk/board/index.php)

- General IT Discussion (https://www.cableforum.uk/board/forumdisplay.php?f=19)

- - Audio interferance (https://www.cableforum.uk/board/showthread.php?t=33666439)

Re: Audio interferance

Quote:

Originally Posted by Uncle Peter (Post 35044396)

Does the Audigy card have a drivebay mounted break-out box connected via ribbon cable?

Yes it does. I've got the platinium version. The Audigy and drive bay is not installed at the moment and as I said - I think it's broken...

Re: Audio interferance

Okidoki no problem, I was going to say if the drivebay box was installed it could be providing another path to ground which is not desirable. Ground loop issues aren't always characterised by hum, they can also be the source of digital noise problems like you're experiencing.

Switched mode power supplies can be bad guys too and if you're running through a PA on stage with these issues unresolved then you can forget it. On the occasions I've used my laptop and firewire audio interface live it's been with a fully balanced chain with all gear running off a power conditioner. Even then you can still detect a bit of digital hash in the noise floor when nobody is playing.

Re: Audio interferance

For audio stuff you are best taking it away from you PC internals. Most audio cards and onboard sound systems are not for those actually wanting to use them for anything worthwhile.

My old ASUS M/B with onboard sound had a noise floor 40dB above the theoretical value. A cheap and cheerful USB one (circa Â£30) I borrowed from work was about 10dB above.

Moving cables around inside the PC will have a limited effect as much of the noise is induced in the ground/shielded side anyway. Just because two points are electrically ground does not mean they are at the frequencies flying around inside a PC. At 3.4GHz a tiny unshielded wire is a very effective aerial.

Yamaha do some very good pro equipment for PCs. A bit expensive though so it depends how serious you want to be.

As for it going away when the HD is being accessed...most switching power supplies require a minimum load for stability. Few peripherials in a PC use 5V apart from HDs and CDs/DVDs. If for effiency the design of the power supply is a "burst mode" design (I have no idea one way or t'other), they are notorious for radiating from DC to XRAYs. :)

As previously mentioned, a balanced input with twisted pair wires will gain you alot.