NTL Primary DNS Address??

[winpac]

I have just upgraded the firmware and now I can't connect through it until I get all the config data back in, some of which I did not note down.

Can anyone please tell me the Primary DNS Address & Secondary DNS Address?

Thanks

[vmtec]

are you going throu a router ????

[Rik]

Primary Server 194.168.4.100
Secondary Server 194.168.8.100

[vmtec]

go into comand prompt
windows dos and type cmd
then when in dos mode type ping it should give you all your ip addresses including dns and secondary

[winpac]

DHCP wasn't working from the WAN.
Looks like I needed to switch off/on the modem & router. It appears to be OK now.

Thanks for the info.

[MetaWraith]

and for those times when NTL's DNS doesn't do it for you, I can recommend OpenDNS

208.67.222.222
208.67.220.220http://www.opendns.com/

[Stuart]

go into comand prompt
windows dos and type cmd
then when in dos mode type ping it should give you all your ip addresses including dns and secondary

That command won't give any DNS info.

Ping is used to verify connectivity to a remote site, and gives the following output.


Pinging www.bbc.net.uk [212.58.226.232] with 32 bytes of data:

Reply from 212.58.226.232: bytes=32 time=14ms TTL=122
Reply from 212.58.226.232: bytes=32 time=13ms TTL=122
Reply from 212.58.226.232: bytes=32 time=14ms TTL=122
Reply from 212.58.226.232: bytes=32 time=14ms TTL=122

Ping statistics for 212.58.226.232:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 13ms, Maximum = 14ms, Average = 13ms


The command you are referring to is "IPconfig /all" which will give the DNS and various other info.

Also, note, if you are connected to a router, the DNS entry returned may be the IP of the router (some routers operate their own DNS servers which just forward any requests).